Reference number
ISO/TR 10358:2021
Technical Report
ISO/TR 10358:2021
Plastics pipes and fittings for industrial applications — Collection of data on combined chemical-resistance
Edition 2
2021-06
Technical Report
Read sample
ISO/TR 10358:2021
77005
Published (Edition 2, 2021)

ISO/TR 10358:2021

ISO/TR 10358:2021
77005
Language
Format
CHF 216
Convert Swiss francs (CHF) to your currency

Abstract

This document collects available data on combined chemical resistance of thermoplastic materials typically used to manufacture piping components for industrial applications, against fluids over a range of temperatures.

The base thermoplastic materials covered by this classification are:

Polyethylene                                                              PE

NOTE 1        The PE considered in this document corresponds to PE-HD, with a minimum density value of 0,935 g/cm3 (e.g.: PE63, PE80, PE100, PE100-RC, PE-RT).

Polypropylene                                                           PP (PP-R and PP-RCT, PP-H, PP-B)

Polyvinyl chloride, unplasticized                          PVC-U

Polyvinyl chloride, chlorinated                             PVC-C

Polybutylene                                                              PB

Acrylonitrile/butadiene/styrene                         ABS

Polyvinylidene fluoride                                          PVDF

NOTE 2        This document considers homopolymer PVDF.

Cross-linked polyethylene                                     PE-X (PE-Xa, PE-Xb, PE-Xc)

Ethylene chloro trifluoro ethylene                       ECTFE

Polyamide, unplasticized                                        PA-U (PA-U11, PA-U12)

NOTE 3        This document focuses on PA-U11 and PA-U12 only, as these long chained PA-U are standardized according to ISO 16486-1; short chained (e.g. PA 66) and plasticized PAs are not used for monolithic plastic piping components.

Polysulfone                                                                PSU

Perfluoralkoxy                                                          PFA

NOTE 4        Temperatures higher than 200°C can be applied after an evaluation with the raw material manufacturer.

Polytetrafluoroethylene                                         PTFE

NOTE 5        Temperatures higher than 200°C can be applied after an evaluation with the raw material manufacturer.

 

 

Polyphenylene sulphide                                          PPS

NOTE 6        PPS is new with regards to industrial application and chemical resistance issues; for this reason, manufacturers and end-users are advised to assess the chemical suitability of the material.

General information

  •  : Published
     : 2021-06
    : International Standard published [60.60]
  •  : 2
     : 215
  • ISO/TC 138/SC 3
  • RSS updates

Got a question?

Check out our Help and Support