Abstract
Specifies the general principles and the procedures to be followed with thermoplastics in the preparation of specimens, which are homogeneous and isotropic and from which test specimens may be machined or stamped. In order to obtain mouldings in a reproducible state, the main steps of the procedure, including four different cooling methods, are standardized. Two alternative kinds of moulds, flash moulds and positive moulds, are specified.
General information
-
Status: WithdrawnPublication date: 1986-10Stage: Withdrawal of International Standard [95.99]
-
Edition: 2Number of pages: 4
-
Technical Committee :ISO/TC 61/SC 9ICS :83.080.20
- RSS updates
Life cycle
-
Previously
WithdrawnISO 293:1974
-
Now
-
Revised by
WithdrawnISO 293:2004