ISO 2507-1:1995
p
ISO 2507-1:1995
20854
Status : Published (To be revised)
This standard was last reviewed and confirmed in 2017. Therefore this version remains current.
This standard will be replaced by ISO/WD 2507-1
en
Format Language
std 1 40 PDF
std 2 40 Paper
  • CHF40
Convert Swiss francs (CHF) to your currency

Abstract

The method specified is based on determining the temperature at which a standard indenter, under a force of 50 N ± 1 N, penetrates 1 mm into the surface of a test piece cut from the wall of a pipe or fitting while the temperature is raised at a constant rate. Is applicable only to thermoplastics materials for which it is possible to measure the temperature at which the rate of softening becomes rapid. Is based on ISO 306:1994 which, however, applies to materials in the form of sheets.

General information

  •  : Published
     : 1995-02
    : International Standard to be revised [90.92]
  •  : 1
     : 4
  • ISO/TC 138/SC 5
  • RSS updates

Read sample 

Preview this standard in our Online Browsing Plateform (OBP)

Life cycle

Got a question?

Check out our FAQs

Customer care
+41 22 749 08 88

Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)