Resumen
This document specifies a laboratory method for measuring the vibration at the handle of fastener driving tools. It is a type test procedure for establishing the vibration value on the handle of a hand-held power tool operating under a specified load.
This document is applicable to fastener driving tools driven pneumatically or by other means, using nails, staples or pins.
This document is applicable to tools with single sequential actuation, contact actuation, contact actuation with automatic reversion or continual contact actuation (see Figures 1 to 3).
This document is not applicable to tools operating in full sequential mode due to their much longer intervals in between individual actuations. However, to provide an indication for comparison of different tools of this type (see Figures 4 and 5), Annex C provides informative guidance.
NOTE Today current knowledge does not allow any conclusions regarding physiological and pathological effects between isolated shocks and continuous shock sequences, and their repetition rates.
Preview
Informaciones generales
-
Estado: PublicadoFecha de publicación: 2022-02Etapa: Norma Internacional publicada [60.60]
-
Edición: 1Número de páginas: 21
-
Comité Técnico :ISO/TC 118/SC 3
- RSS actualizaciones
Ciclo de vida
-
Anteriormente
RetiradaISO 8662-11:1999
RetiradaISO 8662-11:1999/Amd 1:2001
-
Ahora
Got a question?
Check out our FAQs
Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)