ISO/TR 3313:2018

недоступно на русском языке

Текущий статус : Опубликовано (Hа стадии пересмотра)

Последний раз этот стандарт был пересмотрен в 2022. Поэтому данная версия остается актуальной

	Формат	Язык
std 1 173	PDF + ePub
std 2 173	Бумажный

CHF173

Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

ISO/TR 3313:2018 defines pulsating flow, compares it with steady flow, indicates how it can be detected, and describes the effects it has on orifice plates, nozzles or Venturi tubes, turbine and vortex flowmeters when these devices are being used to measure fluid flow in a pipe. These particular flowmeter types feature in this document because they are amongst those types most susceptible to pulsation effects. Methods for correcting the flowmeter output signal for errors produced by these effects are described for those flowmeter types for which this is possible. When correction is not possible, measures to avoid or reduce the problem are indicated. Such measures include the installation of pulsation damping devices and/or choice of a flowmeter type which is less susceptible to pulsation effects.

ISO/TR 3313:2018 applies to flow in which the pulsations are generated at a single source which is situated either upstream or downstream of the primary element of the flowmeter. Its applicability is restricted to conditions where the flow direction does not reverse in the measuring section but there is no restriction on the waveform of the flow pulsation. The recommendations within this document apply to both liquid and gas flows although with the latter the validity might be restricted to gas flows in which the density changes in the measuring section are small as indicated for the particular type of flowmeter under discussion.

Preview

Вы можете ознакомиться с данным стандартом в нашей онлайн-библиотеке (OBP)

Общая информация

Текущий статус
: Опубликовано

Дата публикации
: 2018-03

Этап
: Подтверждение действия между-народного стандарта [90.93]
Версия
: 4
Технический комитет :
ISO/TC 30/SC 2

ICS :
17.120.10
RSS обновления

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами

+41 22 749 08 88

customerservice@iso.org

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)