ISO 13012-1:2018

Тезис

This document specifies the boundary dimensions, other relevant dimensions and the corresponding tolerances of accessories for sleeve type linear ball bearings which are specified in ISO 10285.

This document applies to:

— the following housings:

— closed and adjustable flangeless housings for series 1 sleeve type linear ball bearings,
— closed and adjustable flanged housings for series 3 sleeve type linear ball bearings,
— open flanged housings for series 3 sleeve type linear ball bearings,
— closed and adjustable flangeless housings for series 3 sleeve type linear ball bearings,
— open and open adjustable flangeless housings for series 3 sleeve type linear ball bearings;

— the following shaft support rails:

— standard height shaft support rails for series 3 sleeve type linear ball bearings,
— low height shaft support rails for series 3 sleeve type linear ball bearings;

— the following shaft support blocks:

— flanged shaft support blocks for series 1 and 3 sleeve type linear ball bearings,
— flangeless shaft support blocks for series 1 and 3 sleeve type linear ball bearings;

— solid and tubular shafts for series 1 and 3 sleeve type linear ball bearings.

Общая информация

Текущий статус
: Published

Дата публикации
: 2018-12
Версия
: 2
Технический комитет
: ISO/TC 4/SC 11 Linear motion rolling bearings
ICS
:
21.100.20 Rolling bearings

Приобрести данный стандарт

	Формат	Язык
std 1 124	PDF + ePub
std 2 124	Бумажный

CHF124

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами

+41 22 749 08 88

customerservice@iso.org

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

Будьте в курсе актуальных новостей ИСО

Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.

недоступно на русском языке