ISO 12240-4:1998
p
ISO 12240-4:1998
24246
недоступно на русском языке
Текущий статус : Опубликовано (Hа стадии пересмотра)
Последний раз этот стандарт был пересмотрен в  2020. Поэтому данная версия остается актуальной
ru
Формат Язык
std 1 61 PDF
std 2 61 Бумажный
  • CHF61
Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

This part of ISO 12240 specifies dimensions, tolerances and radial internal clearances for various dimension series of spherical plain bearing rod ends.

The dimensions and tolerances specified in this part of ISO 12240 have been selected to permit the design and use of spherical plain bearing rod ends which incorporate radial spherical plain bearings having various sliding material combinations.

The specified tolerance values apply for finished spherical plain bearing rod ends before any coating, plating, ring splitting or fracturing.

Spherical plain bearing rod ends need not conform to the designs illustrated but compliance is required as regards dimensions, tolerances and radial internal clearances specified.

NOTE — Spherical plain bearing rod ends for airframe applications and specific spherical plain baring rod ends for direct connection to hydraulic cylinders are not covered by this part of ISO 12240.

Общая информация

  •  : Опубликовано
     : 1998-08
    : Подтверждение действия между-народного стандарта [90.93]
  •  : 1
  • ISO/TC 4/SC 7
    21.100.10 
  • RSS обновления

Preview 

Предварительно ознакомьтесь с этим стандартом в нашем Он-лайн библиотека стандартов (OBP)

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)